新網站功能測試中,非最終報價且無法下單,敬請見諒!

HydraNFC 屏蔽和 HydraNFC 天線

HydraNFC Shield and HydraNFC Antenna

貨號 113990077
售價 3,183.70 (未稅)
含營業稅 3,342.88
廠商庫存 0

原始網址: https://www.seeedstudio.com/HydraNFC-Shield-and-HydraNFC-Antenna-p-1974.html

描述

HydraNFC 是一款 NFC 屏蔽硬件,可為任何對 NFC 調試 / 黑客入侵 / 開發感興趣的人嗅探,讀 / 寫或仿真任何 13.56MHz NFC 標籤(借助直接模式)。
它已被設計為與 HydraBus 一起使用,但也可以與其他 MCU 一起使用(所有 TRF7970A I / O 的突破)。
HydraNFC 與 Proxmark3 硬件(與 HydraBus 結合使用)功能強大,但體積更小,自主,更具擴展性,無需 FPGA(所有工作都在 CortexM4 MCU 中完成,並通過 HydraBus 提供超快速獨特算法實時嗅探和解碼 PICC / PCD NFC 卡)。
特徵
HydraNFC 盾牌:
•口袋大小和重量輕
•具有 4 個用戶按鈕和 4 個用戶 LED 的自主模式(與 HydraBus 一起使用時)
•使用 Texas Instruments TRF7970A NFC 芯片組,可通過連接器 J1 / J2 / J3 完全訪問 TRF7970A 的所有引腳和所有模式
•設備可以執行以下三種模式之一:RFID 和 NFC 閱讀器,NFC 對等設備或卡模擬模式
•支持 ISO15693,ISO18000-3,ISO14443A / B 和 FeliCa 集成編碼器的近場通信(NFC)標準 NFCIP-1(ISO / IEC 18092)和 NFCIP-2(ISO / IEC 21481)解碼器和 NFC 啟動器的數據幀,所有三比特率(106 kbps,212 kbps,424 kbps)的主動和被動目標操作以及卡仿真
•可編程輸出功率:來自 13.56-MHz 晶體的 + 20 dBm(100 mW),+ 23 dBm(200 mW),可編程系統時鐘頻率輸出(RF,RF / 2,RF / 4)
•直接模式 0:原始 RF 子載波數據流
•直接模式 1:沒有協議幀的原始數字 ISO 編碼數據
•ISO 模式:全 ISO 幀和錯誤檢查(典型模式)
•使用 U.FL 連接器(包含電纜)或 SMA 支持外部 NFC 天線
•硬件許可證 CC BY NC(用於商業許可證聯繫人 info@hydrabus.com)
•尺寸:54x35x13 毫米
HydraNFC 天線(包含在 HydraNFC 防護罩中):
•U.FL 連接器(包含電纜)或 SMA(包含 SMA 連接器)
•高性能,可以讀取長達 8 厘米的 Mifare 卡(僅限使用 HydraNFC Shield 進行測試)
•尺寸:58x53x4 毫米
HydraNFC 嵌入式固件(需要 HydraBus):
•使用帶 SS 模式的 SPI 在 STM32F4 和 TRF7970A 之間進行通信
•通過帶有 VT100 終端 / 外殼的 microUSB 訪問虛擬串行端口(與支持 USB 虛擬串行端口的任何計算機兼容)。
ChibiOS(OS + 驅動程序)和 microrl 在 VT100 終端中的使用,具有歷史,完成和許多其他很酷的功能
•Vicinity / ISO15693 的基本 UID 讀取(通過 shell 命令)
•Mifare One 卡的基本 UID 讀取(通過 shell 命令)
•ISO14443A 自主模式下的嗅探器模式(NFC 協議分析儀),包括 PICC 和 PCD 以及記錄到 microSD 卡的數據(通過 Mifare One NFC 成功測試)。
Sniffer 與 TRF7970A CLK OUT(13.56MHz / 4)同步,使用 DMA 雙緩衝區實時檢索 NFC 原始比特流,同步並檢測(Tag / PICC = miller modified 或 PCD = manchester)協議,解碼並格式化在每位少於 1us 的 ASCII 碼中,當用戶按下按鈕時,數據存儲在 microSD 卡中(數據也可以在終端中顯示)。
使用 Nexus S 手機讀取 Mifare One 標籤的嗅探輸出示例:
26
TAG 04 00
93 20
TAG cd 81 5f 76 65
93 70 cd 81 5f 76 65 d1 86
TAG 08 b6 dd
...
此版本中的輸出格式:
當它以 4 個空格開始時,它意味著讀寫器(PCD - 接近耦合設備)。
當它以 TAG + 1 空間開始時,意味著 TAG(PICC - 接近集成電路卡)。
數據是十六進制的,只有奇偶校驗被忽略(稍後將在 Proxmark3 上添加!當有奇偶校驗錯誤時...),也不檢查 CRC_A
•HydraBus microSD 卡保存或加載數據。
支持 microSD(FAT16 / FAT32)卡高達 32GB(使用 SanDisk Extreme 32GB 進行測試)
欲了解更多信息並開始使用 HydraNFC,請訪問 HydraBus / HydraNFC 網站,並獲取 HydraNFC 的開放固件(需要 HydraBus)或硬件,請參閱github
如果您在使用本產品時遇到任何問題,請聯繫技術支持

技術細節

重量 GW 33g
電池排除

Description

The HydraNFC is a NFC shield hardware to sniff, read/write or emulate any 13.56MHz NFC tags (with the help of direct modes) for anyone interested in debugging/hacking/developing for NFC.
 
It has been designed to be used with HydraBus but can also be used with other MCU (breakout of all TRF7970A I/O).
HydraNFC is as powerful as Proxmark3 hardware (when combined with HydraBus) but smaller, autonomous, more extensible and without requiring an FPGA (all is done in CortexM4 MCU with the help of HydraBus with ultra fast unique algorithm to sniff & decode in real-time PICC/PCD NFC cards).
 
Features
HydraNFC shield:
 •Pocket size and light weight
 •Autonomous mode (when used with HydraBus) with 4 User buttons and 4 User LEDs
 •Use Texas Instrument TRF7970A NFC chipset with full access to all pins and all modes of TRF7970A through connectors J1/J2/J3
    •The device can perform in one of three modes: RFID and NFC reader, NFC peer, or in card emulation mode
    •Supports Near Field Communication (NFC) Standards NFCIP-1 (ISO/IEC 18092) and NFCIP-2 (ISO/IEC 21481), completely Integrated Protocol Handling for ISO15693, ISO18000-3, ISO14443A/B, and FeliCa, integrated Encoders, Decoders, and Data Framing for NFC Initiator, Active and Passive Target Operation for All Three Bit Rates (106 kbps, 212 kbps, 424 kbps) and Card Emulation
    •Programmable Output Power: +20 dBm (100 mW), +23 dBm (200 mW), programmable System Clock Frequency Output (RF, RF/2, RF/4) from 13.56-MHz Crystal
    •Direct Mode 0: Raw RF Sub-Carrier Data Stream
    •Direct Mode 1:Raw Digital ISO Coded Data Without Protocol Frame
    •ISO Mode: Full ISO Framing and Error Checking (Typical Mode)
 •Support external NFC Antenna with U.FL connector(cable included) or SMA
 •Hardware licence CC BY NC (for commercial licence contact info@hydrabus.com)
 •Size: 54x35x13 mm
HydraNFC Antenna (included with HydraNFC shield):
 •U.FL connector (cable included) or SMA (SMA connector included)
 •High performance, can read Mifare card at up to 8cm (Tested with HydraNFC Shield only)
 •Size: 58x53x4 mm
HydraNFC embedded firmware (requires HydraBus):
 •Use SPI with SS mode for communication between STM32F4 & TRF7970A
 •Virtual Serial Port access through microUSB with VT100 terminal/shell (compatible with any computer supporting USB Virtual Serial port).
Usage of ChibiOS (OS+Drivers) and microrl for VT100 terminal with history, completion and lot of other cool features
 •Basic UID read for Vicinity/ISO15693 (through shell command)
 •Basic UID read for Mifare One card (through shell command)
 •Sniffer mode (NFC protocol analyzer) in autonomous mode for ISO14443A including both PICC and PCD with data logged to microSD card (tested with success with Mifare One NFC).
Sniffer is synchronized with TRF7970A CLK OUT (13.56MHz/4), use DMA double buffer to retrieve in real-time NFC raw bitstream, synchronize and detect (Tag/PICC=miller modified or PCD=manchester) protocol, decode it and format it in ASCII in less than 1us per bit, when user press a button the data are stored in microSD card (data can be also displayed in Terminal).
Example of sniffed output with a Mifare One tag read by a Nexus S phone:
    26
TAG 04 00
    93 20
TAG cd 81 5f 76 65
    93 70 cd 81 5f 76 65 d1 86
TAG 08 b6 dd
...
Output format in this version:
When it start with 4 space it means Reader/Writer (PCD – Proximity Coupling Device).
When it start with TAG+1 space it means TAG(PICC – Proximity Integrated Circuit Card).
Data are in hexadecimal and only Parity is omitted (will be added later like on Proxmark3 with ! When there is parity error ...), also the CRC_A is not checked
 •HydraBus microSD card to save or load data.
Support of microSD (FAT16/FAT32) card up upto 32GB (tested with SanDisk Extreme 32GB)
 
For more info and to get started with your HydraNFC, visit the HydraBus/HydraNFC website and for open firmware (HydraBus Required) or hardware for HydraNFC see github.
 
If you encounter any problems when using this product, contact the technical support.

Technical Details

Weight G.W 33g    
Battery Exclude